Losing Axis on Controller Display When adjusting Stall Current

Machines (Original/PRO)
1

Hey Folks!

Recently when I’ve tried to adjust the stall current on an axis, once I turn back to the main controller display, my Y axis disappears.

Once this happens, I am able to bring it back to the display by resetting the machine’s configuration settings. But this is preventing me from being able to adjust stall currents.

Any thoughts?

Thank you!

2

Update:

Found a way to keep the 3 axis up on the controller display when adjusting stall current…just a mix of going back and forth through the axis selection until it reappears…

However…Now even at a stall current of .1 Z will not home properly…

Any Thoughts?

Running the most recent firmware update.