I am working on an x-50 journeyman and I am a total newcomer to this hobby. I am trying to get my machine set up but notice that once I have homed the machine, I cannot jog the machine past the halfway point on either the X or Y axes. If I don’t home the machine first, I am able to jog the machine around the entire work area with no problems. This might be an obvious answer to a stupid question, but am I doing something wrong?
Hey LJ,
on the menu, choose the ADMIN page and load the defaults for your model (Configuration → Reset).
Welcome to the forum!
2 Likes
Thank you! I am so excited to be part of this community and to get help from generous and knowledgeable folks like yourself. Thanks again!
2 Likes
Thanks, this helped me as well