Hey Soutish,
yes, the settings are different because the buildbotics-derived Onefinity controller of the Original/X-50/PRO Series controls VFDs with Modbus via a RS-485 serial communications interface (two-wire interface), while the MASSO G3 Touch of the Elite Series unfortunately does not support Modbus and has to control the VFD through a programmable input terminal for FWD/REV/STOP spindle and a analog 0–10 V voltage line for SPEED (FREQUENCY). Therefore the settings for “source of RUN commmand” and “source of frequency/speed control” must be set differently depending on which CNC controller you have. Luckily nearly all VFDs I know support both methods.
Regarding wiring, here is a table that shows the wiring when using the spindle control cable:
Welcome to the forum!