The problems continue. With the tester from Onefinity helping, we reset the Masso probably a dozen times, unplugged and plugged in connections a couple of times. Finally, the B motor alarm went away. I loaded three programs and ran them successfully. Today, I plug in the USB and the Masso will not …

Did you open up the Masso unit and check the USB port/wiring? Another idea would be to put the usb stick into one of the other 3 ports to see what happens. The masso Touch G3 has four USB ports. Three inside and one routed out

Did not know about the other USB ports. I will them a try.

Thanks Woodpecker. I went inside and pluged in directly to the port that connects to the outside USB. It worked. So, replugged all the connections. It is working now.

Forum thread faq is already here about this: [image] Elite Masso USB Disconnects Troubleshooting FAQ USB Disconnect (FAQ) If you are experiencing USB disconnects on the Elite Masso, please go through the following troubleshooting steps. Basic testing includes c…

Masso will not recognize USB

Elite Series (Masso & Redline) (Gen 1) Controller (MASSO) Discussion

OnefinityCNC (Onefinity CNC Official ✅) March 11, 2024, 12:48am 5

Forum thread faq is already here about this:

Topic		Replies	Views
Elite Masso USB Disconnects Troubleshooting FAQ USB Disconnect (FAQ)	0	2616	April 30, 2023
Masso USB Configuration (solved with link) Elite Series (Masso & Redline) (Gen 1)	5	593	January 2, 2024
Unresponsive Masso Touch Screen Troubleshooting (Elite Series)	4	178	February 23, 2026
Elite USB or not to USB Uncategorized	8	854	September 2, 2023
Constant disconnect of usb drive (Masso) (solved see faq) Elite Series (Masso & Redline) (Gen 1)	43	3157	July 27, 2024

Masso will not recognize USB

Related topics