Onefinity Riser Blocks

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Chris,

@ChrisS

The foreman has a negative clearance where the x mounts to the y because theyre lower than the feet. I guess maybe it’s called the linear bearing block…

To compensate they added like 1/4" risers for the y feet that are needed on the foreman, unless you use the qcw. Even with these risers, there’s only like 1/8", so i added 3/4" scrap plywood giving me room for a towel for when i have to oil it up.

Ah okay. Thanks for the explanation. You are right, I remember I realized it when unpacking the X-50 axis of my Journeyman. This is also the reason why the foot of 50 mm rail is floating above ground in this image here:

Differences Between X-50 Rails (upgrade) and X-35 Rails (standard)

I remember having seen those riser blocks here. What are they made of?