Capers
(MICHAEL CAPERS)
April 11, 2025, 5:46pm
1
Hi everyone. I have an X Axis issue. I replaced the X Axis wire thinking that was the problem. Still same issue. Any help would be appreciated. This is holding me up from getting orders out. Thanks!
OnefinityCNC
(Onefinity CNC Official ✅)
April 11, 2025, 5:51pm
2
There is an FAQ for that!
Rail is getting hung/stuck/grinding.
Special notes to read before following each step:
A rail getting stuck/hung is typically one of two things, either a wire/connection issue or the grub screw on the ball screw isn’t tight on the side that isn’t moving.
One thing to remember, stall homing adjustments do NOT affect rail movement during cutting or jogging. If the rail isn’t moving correctly during cutting or jogging, incorrect stall homing is an affect of this greater issue.
Any time the axis …
1 Like