Prob issue not sure what is going on

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Troy,

if you create a 3D model that is exactly as big as the workarea, you got to make sure that your toolpath zero coordinate is zeroed / probed absolutely exactly on the corresponding position in real.

If you don’t, you tell the machine to mill outside the workarea which it must of course refuse (with the errors shown).

@Aiph5u

as long as you have not created a g-code toolpath of your own, uploaded and selected it in the machine, and probed or manually set your workpiece zero coordinate, this is not an issue and can (must) be safely ignored.

If you have created a g-code toolpath of your own, uploaded and selected it in the machine, and probed or manually set workpiece zero coordinate, then this error tells you that your g-code toolpath wants the machine to mill outside its workarea, which will in no case go. In this case, either your 3D model is too big, or you’ve probed or set manually your workpiece zero coordinate in the wrong position.

This support document may help you:

• Help! My Toolpath says ‘Under’ or 'Over"! (with videos)