I’m hoping between 1 or two weeks, but things keep pushing between it. So I can’t make any hard promises.
No, there is one older over here where I introduced my first prototype… Wel… didn’t expect it to be a prototype, it was just something I made haha. That discussion lead to the production panels. Side note: I personally still use this original panel without problems.
https://forum.onefinitycnc.com/t/onefinty-control-panel-remote-gamepad-replacement-with-lots-of-extra-options/
In my setup the Onefinity controller is near the panel. And I I needed to wind up and tuck away a lot of wire to get it neat. I expect most users have the Onefinity controller nearby that’s why I used 1m wires. But like I said, if it’s too short the length can easily be lengthen. Also it’s just an basic USB mini cable, you can find different lengths for cheap everywhere (probably in house 
) Just make sure it is a data cable, not just a charging cable.
The relays are now on the right side of the board. As far away of the microcontroller possible. I need to take new product photo’s, I shall post them when ready.
Probably not, I had just one user with that specific problem. And I know that more user control lights with the extra ACC buttons. But just in case someone else had the same problem I added it to the troubleshooting guide. Last item, but needs to be updated with the latest pcb revision:
If I get questions I usually update the documentation if I think someone else could benefit from that information.