Rotary "Keep Out" Zone?

Onefinity Rotary 4th Axis 'The Revolution'
1

I finished installing and setting up a rotary on my Woodworker Elite (on QCW with rolling folding stand). I have mine oriented along the Y Axis, with the rotary in the right front and tail piece in right rear. I am thinking I may want to leave it permanent, but I would risk a crash on the rotary in the right front. Is it possible to configure the Masso with a “Keep Out” zone where the rotary is to avoid any possible “mistakes”.

I tried searching the forum, but TBH, I wasn’t sure what language to use.

2

You can adjust your soft limits to avoid it but have to reset them when you use the rotary.
Pat

3

This request has come up in the Masso forum, but I do not believe it is scheduled for any upcoming firmware releases. Phase 1 of BETA (v5.100b) has been out for over 12 months, and there were phases 2 and 3 still to go as part of the rollout. So, not likely any time soon.

4

Thanks for the reply. I am starting to lurk around in the Masso forum, lot’s of good stuff over there.