Stopping a Run and then jogging should not break software

[Ruairisdad (Barry O.)]

@Controller unresponsive after using the pause or stop buttons

There are some rare instances when the controller becomes unresponsive after using the pause or stop buttons. A little background. The controller we use is built off the open source Buildbotics project that existed for a few years before Onefinity’s inception. They use a raspberry pi 3b (released in 2016). It uses a Broadcom BCM2837 chipset. While a file is running, it streams the Gcode from its CPU through the serial bus to the custom board chipset to the motor drivers. The chipset used o…

Oh this is useful; thanks.