I have been using the onefinity post process in Fusion 360 for my g-code. I have been having a problem with the tool path creeping to the right… it gets about 1/2" off of where it starts. What am I doing wrong? I have reset the carving, leaving the same axises that I started with, to see if it wa…

Tool path creeping

ben (Benoît Marchal) May 26, 2021, 11:43am 2

I had a similar problem and resolved it with the help of the community, extensive answer here.

Topic		Replies	Views
Post-Processor bugs (Fusion360) Controller (Buildbotics) Discussion	14	1720	October 15, 2021
Tool path shift up for no reason	3	562	January 21, 2022
Turning toolpath Fusion 360 Fusion 360	3	372	February 22, 2024
Fusion 360 and Journeyman x50 calibration or postprocess?	18	428	October 29, 2024
Fusion 360: "alignment" problem in CAM Fusion 360	10	1924	August 5, 2022