The problem is that I am trying to cut the test file that is loaded on the controller from the factory. Without cutting anything. Cutting air. I can not seem to manually set the zero, it seems to look for the probe and then faults out with a z axis e stop. Always saying 4 plus mm out of range. How d…

Hey Todd, [image] todd1234: The problem is that I am trying to cut the test file that is loaded on the controller from the factory. Without cutting anything. Cutting air. I can not seem to manually set the zero, it seems to look for the probe and then faults out with a z axis e stop. Always say…

The code I am trying to run is the code that is made by Onefinity and loaded on the controller. I have to assume they know what they are doing . How do I handle this? How do I correct this? I know the machine is working, however what setting do I have to use?

Hey Todd, [image] todd1234: The code I am trying to run is the code that is made by Onefinity and loaded on the controller. I have to assume they know what they are doing . sure, and what they say about this file is: [image] Z axis won’t zero after homing the ‘1f’ test file isn’t for use…

ugh. I missed the point of the probe. That makes sense. Thanks guys.

If you’re wanting to probe manually, there is no need to hit the probe z button at all. Lower your spindle/router to where you want to set z zero. Once you have it at the height you want your z zero, touch the map marker icon (inverted teardrop icon) on the z line only. Once you’ve do that, your …

Hey Todd, the long answer is: If you are running a g-code program (i.e. the machine is in auto mode and not in manual mode) and the machine encounters a G38.2 (Straight Probe) command, the only way to escape this command is to allow the machine to finish the probing procedure with a successful resu…

Thank you for the response. The problem is on my side. I had made an assumption that the g code for the sign would not have needed the probe, considering that not everyone would have ordered the proble. so why provide code as a quick start that could not be done? This was a mistake that I made. Alm…

Trying to cut air as a test but can not

349iq2345 August 12, 2022, 8:12pm 4

Hey Todd,

sure, and what they say about this file is:

Further video watching

Topic		Replies	Views
Reason to zero z	7	1267	November 4, 2021
Z Error while probing Tool Troubleshooting (X35/X50)	6	1033	January 7, 2023
Wrong way z and over on the z axis Troubleshooting (X35/X50)	13	1336	August 29, 2022
Z axis won’t zero after homing Troubleshooting (X35/X50)	28	3263	June 21, 2022
Homing VS XYZ probing	6	629	August 11, 2022

Trying to cut air as a test but can not

Further video watching

Related topics