VCarve Time Estimate vs Controller Time Estimate

I assume this is related to the controllers acceleration patterns however when doing photo vcarve the application says 15m36s but the controller is showing 53m17s.

Anyone have any tips for getting the estimated time to align?

we’re releasing a firmware update soon that will adjust s curve acceleration to speed things up in cut time.


My guess so far is it does not seem to a fast Z move unlike on the X and Y. I have been able to speed up my 3D cuts by reducing the safe Z reducing the lift between cuts. Sometimes is close sometimes the times are way off it just depends on what the cut is.

1 Like