Wiring H100 or V70 VFD to GX-12 6-pin spindle control on Elite Masso G3

Spindle/VFD (Aftermarket)
14

Hey Andre, hey Tom @TMToronto,

for someone who is not familiar with electronics, neither the pin designations on the Masso controller nor those on the VFD are self-explanatory. And here with the GX-12 6-pin connector, we have an additionel level between the two.

Andre, please report if you succeeded with the wiring shown above, and you may also provide the settings for setting RUN command and SPEED command you needed to enter into your specific VFD.

1 Like