Hey Brenden,
I don’t have a photo documentation (although planned), but here you can see the WJ200-specific pins that you have to use:
| Internal Masso Spindle Control Interface | Function | GX12 6-pin connector on back of Elite Masso G3 Touch (internal wire colors) | Wire color and pin on | VFDs Hitachi WJ200 or Omron MX2 | |
|---|---|---|---|---|---|
| G1 or G2 or G3 or G4 or G5 | GND | pin 1 black | pin 1 black | goes to | "L" |
| SC1 | 0-10 V Analog | pin 2 red | pin 2 red | goes to | "O" |
| SC5 | CW | pin 3 yellow | pin 3 yellow | goes to |
“1 (FWD)” |
| SC4 & SC 6 | Common | pin 4 green | pin 4 white | goes to |
“L” |
| Not connected | pin 5 white | ||||
| SC7 | CCW | pin 6 blue | pin 5 green | goes to |
“2 (REV)” |
Important: The short bar must be on “P24” and “PLC”, not on “L”! (image on the left is correct).
On WJ200 settings, there also must be:
A001 (source of motor speed command) set to “01” (analog input) and
A002 (source of run command) set to “01” (control terminals).
– Source: Hitachi WJ200 or Omron MX2 manual
All this applies to both Hitachi WJ200 and Omron MX2.
Please note hint from Onefinity manufacturer: