Where can a person find the cable connector to plug into the spindle control in the bottom of the control box, there is reference to a GX12 in the manual but I ordered them and they re too large.
Thanks, Pat
Hey Pat,
possibly here ←
Onefinity Elite Series Installation and Operation Instructions (PDF), page 38
Further reading
-
Masso Documentation: Spindle VFD examples
(Control spindle run/stop and rpm through an analog voltage input on your favorite VFD, since on the Masso ModBus support is not yet implemented).
2 Likes
Hxchen 6 Pin Metal Male Female Panel Connector 12mm GX12-6P Silver Aviation Plug - (2 Sets)
Size:GX12-6P
This one on Amazon was a perfect fit. $7.99 for 2
1 Like
Thank you both for this
Pat
1 Like
I ended bypassing this connector and wiring directly to the G3. I followed the instructions on this video, https://youtu.be/uW6sSfKCyW0
Cables with tape were from the existing port, the blue cable to the left is for the router and vac outlets which I don’t need.
2 Likes