Boot up the machine to do some work, homed machine no issue, drove the machine to workpiece to probe and after setting XYZ on my work piece I noticed the probe wasn’t quite where it needed to be, so I went to drive the machine back to the probe and re-do the XYZ. All of a sudden the X axis started …

Wire connection issue. In the 10s of thousands of machines we’ve sold, we’ve seen 1 motor go bad. We can say with 99.99999% confidence it’s a wire: [image] Support: How to determine if a wire or motor is damaged Troubleshooting This faq is used by support to determine if…

X Axis Stepper Grinding

Machines (Original/PRO) Troubleshooting (X35/X50)

Aiph5u (Aiph5u (not affiliated with Onefinity)) November 18, 2023, 10:41pm 4

Hey Tyler,

this is a cable / connector problem. See point 3A in the first link below.

See these Support documents in the FAQ section:

Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)
Axis moving in opposite direction that told to when jogging
Support: How to determine if a wire or motor is damaged

1 Like

Topic		Replies	Views
Is my X Axis stepper motor dead? Troubleshooting (X35/X50)	5	861	March 27, 2022
X axis is locked up? Troubleshooting (X35/X50)	3	1966	March 6, 2022
Noisy X-Axis after crash Troubleshooting (X35/X50)	4	553	June 13, 2022
Did my stepper motor just die? Troubleshooting (X35/X50)	23	2536	November 4, 2021
Apparent X Axis Failure	7	761	April 12, 2021

X Axis Stepper Grinding

Related topics