Hello, this may be a silly but I’m going through the oiling maintenance video and it says there’s an oil port screw on each of the y axis rails and one on the X axis. I have the X50 rail and cannot find the port. Is there something different on this, opposed to the 35 mm rail?

The following may be helpful. [image] [image] X-50 Woodworker x-axis oil port screw? The Onefinity manual states that oil should be added to the oil ports of the ball screws periodically. Where is the x-axis oil port on the X-50 Woodworker? I can find the oil port scr…

I found that hole but there is no bolt in it. Is that how it’s supposed to be or is it missing?

The second link I gave - under the photo - is from a thread that discusses that. Seems some X50s shipped with a missing bolt, and 1F sent replacements in some cases. I would reach out to 1F support.

Only one side of the block gets a bolt, the other doesn’t need it.

When I thought I had found the Y axis oil port on my X35 woodworker, I flooded (per Onefinity maintence video) it with oil and most of it ended up on my waste board. It was not coming out of the mouth of the hole. Was I using the wrong hole? Maybe flooding it was too much? Thanks, Mark

X50 oil port Location

Elite Series (Masso & Redline) (Gen 1)

TMToronto March 28, 2022, 3:32pm 2

The following may be helpful.

Topic		Replies	Views
X-50 Woodworker x-axis oil port screw?	8	1733	March 11, 2022
Z axis ball nut oil port screw	6	1736	January 15, 2022
Maintenance - Ball Nut doesn't match video Elite Series (Masso & Redline) (Gen 1)	1	89	December 8, 2025
Are Y-Axis and X-Axis perfect 90 Degrees? Troubleshooting (X35/X50)	18	1244	June 10, 2023
X-Axis Grinding and Binding (solved, bad wire connection) Original/PRO Series (Buildbotics) (Gen 1)	17	2110	July 12, 2023

X50 oil port Location

Related topics