I posted this earlier in the Firmware forum I was told this was not a firmware issue. Problem: Sometimes the Y axis moves in different directions. The right Y-axis rail moves forward. The left Y-axis moves towards the back. I was told this was a maintenance issue and to perform routine maintenan…

Thank you everyone for the help. I have fixed the opposite direction issue. Steps. Replaced both cables going to Y-Axis rails Removed X-Axis Remounted both Y rails (Made sure they were square. Performed full cleaning maintenance. Flowed the link above Remounted the X-Axis This has fixed the mo…

Was told is wasn’t a firmware issue :stuck_out_tongue: but you left out a key point: moves opposite direction that it’s told. Answer here: [image] Troubleshooting: Rail is getting hung, stuck, grinding, or moving in opposite direction Troubleshooting Rail is g…

So I have a brand new machine and have this exact problem. left/right Y rails trying to go opposite directions. Your link says “hung, stuck, or out of alignment” and not y rails going different directions. Are you saying with a brand new machine I will have to tear apart the rails? I setup my x-50 a…

Did you figure out your exact issue and get it resolved?

Hey Mark, [image] Tidewater_Timber: Your link says “hung, stuck, or out of alignment” and not y rails going different directions. Why don’t you simply click and read the link you are provided by the manufacturer? Then you would have read: [image] Troubleshooting: Rail is getting hung, stu…

I have gone through it all and I still have the problem.

Hey Mark, if you checked all points with no success, then I would write an e-mail to support@onefinitycnc.com .

Hey Mark, [image] 349iq2345: [image] Tidewater_Timber: [image] 349iq2345: [image] Tidewater_Timber: Your link says “hung, stuck, or out of alignment” and not y rails going different directions. Why don’t you simply click and read the link you are provided by the manufacturer? The…

Y axis moving different directions

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

349iq2345 April 2, 2023, 11:55am 8

Hey Mark,

Did you already do this?

Problems with out of sync Y rails

Topic		Replies	Views
Y axis out of sync during a cut Troubleshooting (X35/X50)	5	751	February 3, 2024
Y axis not synchronised Uncategorized	5	2083	May 8, 2023
Y rail and homing problems Original/PRO Series (Buildbotics) (Gen 1)	6	932	November 20, 2023
Y axis not moving Uncategorized	13	2548	March 26, 2021
How to realign the Y rails (x35/x50 machines) Rails	0	1737	November 15, 2022

Y axis moving different directions

Related topics