Z axis ESTOPPED switch not found when homing

[WaywardWoodworker (Derek Lokee)]

You should only need to hit the home button 1 time, it sounds like something is binding somewhere. You might try the resolution in this other thread.

Y axis getting stuck

Try removing the ball nuts from the rails. There are just two screws on each rail near the oil plug. That way you can separate the ball screw action from the rails and figure out where the binding is happening. You should be able to turn the screws by hand, and roll the nut along the screw. I just had mine apart to do some cleaning. [BallNut]