I updated the latest firmware on my one infinity Elite, and after it rebooted my Z axis is locked up. I cant move, It wont home

I saves the files from the original settings before I updated

I just tried reloaded them , but still locked up

Is there a fix or can I go back to the original version? I was having no problems before.

You can always go back to any firmware release. Not sure of the ‘fix’ as you’ve not posted any relevant information (pics or video would be best) yet showing the ‘lock up’.

There isn’t nothing to post. After updating the Z axis will not move. There is nothing to show. Do you want me to send you the flashing alarm?

It’s best to actually email official support after you try downgrading the firmware and reloading the default settings. support@onefinitycnc.com

Did anyone else had this problem after updating to v5.06? The problem only accord after updating. I did nothing else. What will you need because all I get is a z alarm.

Onefinity CNC Forum

Z axis locked after firmware update

Elite Series (Masso & Redline) (Gen 1)

OnefinityCNC (Onefinity CNC Official ✅) November 2, 2023, 6:32pm 2

Did you do what the update says? Back up your settings and reload them after updating?

Read:
https://forum.onefinitycnc.com/t/elite-onefinity-masso-firmware-update-5-06-released-10-30-23-latest/22899

and:

Topic		Replies	Views
Cannot home z Axis Troubleshooting (X35/X50)	1	1409	February 21, 2022
New Masso firmware upgrade to 5.11 causing Z-offset to be incorrect	5	217	April 23, 2026
Z axis locked with journeyman upgrade and 1.3 update (solved, nothing to do with firmware, bad wire, replaced, fixed) Original/PRO Series (Buildbotics) (Gen 1)	1	287	December 13, 2023
Z Motor Alarm at Cycle Start	9	385	July 23, 2024
From 5.07 to 5.13 then back to 5.10... all out of wack Troubleshooting (Elite Series)	12	339	December 23, 2025

Z axis locked after firmware update

Related topics