Z Axis no capability, no re

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Cesar,

in its stock configuration, the Onefinity Standard Series with their connectors with missing serious cable management and even strain relief and the unshielded stepper cables may have unexpected position change issues during operation due to connector problems, or due to introduced EMI. See search results for plunge workpiece for examples.

See

• Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)

and

• Z Axis Moving Unexpectedly (Cutting too shallow or too deep)

for details on the possible causes of such issues.

@OnefinityCNC

Note: Any time the axis moves in the opposite direction than what you direct it to, it’s 100% of the time a bad wire/connection. Sometimes, something as simple as disconnecting and reconnecting the wires connection solves it. Follow below for more help and examples.

Welcome to the forum!