Has anyone else started their machine, homed it, spent some time programing and loading file only to see it prompts you to hom or cancel as if it rebooted on its own?
Pretty sure my power supply is good…
Just happened again in the middle of a large laser engraved 
.
Anyone have any suggestions?
email into support@onefinitycnc.com with a widescreen video so they can assist.
1 Like
A quick look for similar issues indicates a bad power switch
2 Likes
It has to be something as simple as that for sure. I gave it an overhaul (lightly blew out controller and cleaned/oiled) everything. It did do it once more yesterday so I am going to replace switch…cant hurt.
1 Like