I have flashed my SD card in the onefinity computer to solve an on going problem Everything is working fine except when I try to shut down the computer using my touch screen I get a lock up as per the picture I really don’t want to go through another SD flash Any sugestions [IMG_3545png]

Hey Chris, [image] ChrisM: I finally decided that when it says “end Kernel panic” that means it’s good to shut down. The correct way on kernel panic , before powering off, would be to use the Magic SysRequest keycodes for sync (flushing caches to disk), umount filesystems, and poweroff. Howe…

[image] Proper Shutdown on the Onefinity CNC BB controller (original and pro models) Controller (Buildbotics) FAQ [Proper Shutdown on the Onefinity CNC] If the screen does not shut down after powering down and flipping the power switch: There are times when the …

Hey Charles, The solution above, I believe, is for when the screen stays on after you turn off the controller. I think that may not be what you are asking. Are you asking why, when shutting down, the screen stops where you took the picture - instead of going completely black? And then you are not …

When I go through the shut down procedure on my screen the system starts to shut down then the screen displays that command string and everything will stay that way until I shut the rocker switch off on the computer then the screen goes black and the computer shuts down. My concern was the command …

That is exactly what I thought you were asking. It always shuts down this way for me since an update a year or so ago. I have been turning off the rocker switch at that point for a year or more now without any issues. BTW: that is a log report from the system. It will probably also put a copy of …

Hey Charles, it is safe to switch the power off then. No filesystem is mounted so none will get corrupted or marked as dirty.

Can't close program through touch screen

Original/PRO Series (Buildbotics) (Gen 1)

OnefinityCNC (Onefinity CNC Official ✅) December 23, 2024, 2:48am 2

Topic		Replies	Views
Proper Shutdown on the Onefinity CNC BB controller (original and pro models) Controller (Buildbotics) FAQ	0	2856	March 4, 2022
Screen never shuts off Troubleshooting (X35/X50)	4	589	June 7, 2023
Onefinity won't turn off	9	1026	April 29, 2024
Onefinity screen froze on start up	20	1395	April 22, 2022
Shutting down controller Troubleshooting (X35/X50)	10	1203	February 14, 2022

Can't close program through touch screen

Related topics