Screen never shuts off

[griffint (troy)]

hello, untill yesterday i never had this issue; now its all the time. Use too i hit the shut down on the screen like your supposed to it would shut everything off. Now i do it everything shuts off but my screen. It flashes different colors and never shuts off. I was cleanning my ball screws yesterday and the power cord to my screen was in the way so i unplugged it. when done i powered up my cnc but had forgot to plug the power cord for the screen back in. Now its not synced i guess. can someone help me figure this out. I don’t want to have to unplugg the screen every time i shut down. thanks

[Aiph5u (Aiph5u (not affiliated with Onefinity))]

Hey Troy,

you seem to have the “controller rebooting because backfed through monitor USB power” issue. If after shutdown, your screen shows this:

@pwsusi

…this means the controller is already powered down but some power is backfed through the monitor’s USB cable to the controller. The controller reboots then, but the power is not sufficient to complete the bootup.

• Controller not turning off when powering down due to backfeeding of the screens power to the controller
• Proper Shutdown on the Onefinity CNC
• How to connect the Touch Display (7, 8, 10.8")

Also you might want to know:

@Aiph5u

@CNC4Fun

Also, there is some discussion regarding the display not connecting if it is not turned on before the controller. Is it likely that if you turn off the display after pausing, the display may not re-connect when you turn it on again?

The Raspberry Pi inside the Onefinity CNC Controller, when in stock configuration, is set to request the monitor’s capabilities like maximum resolution using EDID. This may fail in case the monitor is not ready at controller startup and result in a fallback to VGA resolution (which is not what you want, especially when using a touch monitor, because the touch device will then not be in sync with the screen content). So it needs to get the right resolution at boot time which is why the Onefinity manufacturer tells the users to first switch to monitor on, and only a few seconds later, the Onefinity CNC Controller.

When switching the monitor on and off later, the Controller should still know the resolution.

However always having to switch on the monitor first and the CNC controller only a few seconds later is not always desirable, e.g. in case you switch everything on with a common power strip.

In this case, you should know that there exists a hack that preconfigures the Onefinity CNC Controller to already know the display resolution at boot time, so you don’t have to worry to turn on the monitor first. You can find it here: Display resolution preset, but to benefit from it, you need to edit and save a config file in the Controller using the CLI. You first need to find out what the native resolution of your monitor is (see monitor’s manual or tech datasheet), and then you find the corresponding mode number in the list on the link provided, and put it into your Onefinity Controller’s boot config text file, and from then on it will always boot into the correct display resolution, even if the monitor is not on at startup.

[griffint (troy)]

thanks for the info but im not having any issues have seen the backfeed to controller and such but im not having any of those issues. Just only issue i have now is i have to power on and off the screen when i did not have too yesterday. thanks for the info though.

[byron361 (BV)]

I have a similar issue and did not have it until the latest version upgrade. My screen freezes after turn off and looks similar but says booting. I was told that is normal and can shut down after that. Maybe the next version will allow it to totally shutdown.

[griffint (troy)]

my equpiment started working right again after i reboot the controller again.