Does anyone have any idea what happened.
After a E-Stop power cycle, the controller wouldn’t power one. I took it apart and blew off the dust with compressed air. both switch and E-Stop worked properly. When turned on after “dusting” the unit powered on but the onscreen E-stop is on and I’m getting all this errors.
Hey Igor,
by the way, if you have wood dust flying around freely in your workshop, I would take precautions like this (and of course like this!)
Welcome to the forum!
The control board has faulted and will need to be replaced. The only place to purchase one is directly from us at support@onefinitycnc.com.
1 Like