When I home my Elite Forman, the Z Slider hits the Y-Rail.
I know this is by design on the Pro, but is it also normal on the Elite?
Is there a way to adjust it to give me a slight gap? I tried moving the sensor and sensor bar, but there is not enough adjustment to make a difference.
Anyone?
Hey John,
It is not normal. Do you get a motor error? That should happen if you hit the end of the rail.
I think it is a design that the sensors are not adjustable.
It would be extremely easy to adjust the XY squareness.
@OnefinityCNC, can you please make the sensors adjustable? I could not square my Elite to a degree I wanted, my QWC frame is not square (even though I loosened all screws once annd tried to pull it in square) and there is not enough wiggle room to move the feet. Adjustable sensors would make squareness adjustments very easy.
I randomly get an error on the X during homing.
I managed to move the sensor a fraction of a mm away from the bar and push the bar a fraction of a mm away from the sensor. This now gives me a little gap between the x and y. But still taps it during the homing cycle.