This firmware is now outdated.
1.3 is officially released here:
This is the RC (release canidate) version of firmware 1.3.0. (updated 7/17/23)
- Fixed G-Code selection (incorrect files loading when uploading new gcode, known issue in 1.2.1)
- VFD 60 (PwnCNC vfd included in dropdown.)
- Various Fixes for ‘stuck progress bar’ on probing.
How To Install:
Updating via USB
You’ll do an update via USB using the following steps:
After downloading, DO NOT UNZIP THE FILE!!!
Copy the blue .bz2 file above onto a usb stick (it must be formatted as fat 32 or ntsf). Click the flyout menu (three bars on top left), general, under firmware click ‘UPLOAD’. Select the 1.3 file.
If you are on firmware 1.0.8 or lower, it may ask for a password.
the password to update will either be buildbotics or onefinity