Firmware Update 1.0.9 (12/17/21) (Outdated Firmware)

[OnefinityCNC (Onefinity Support)]

"Disconnected" Pop up after stopping the job. Only way to regain control is e-stop?

Good day, Everyone. Just got my machine, been experimenting. I noticed that when I stop the job using the stop button, I can no longer move the machine axys using the button. As the matter of fact, I can’t control any of the axys at all with neither homing, nor the directional buttons. I have to press the big red e-stop switch in the web interface but then re-home the machine. Is there a way to release the machine after prematurely stopping the job?