Machine settings seem to be off

[lorenmbrenner (Loren)]

Hey there,

I recently updated the firmware for my elite foreman. I may have done something incorrectly. Now my x and y rails move WAY too quickly. My x,y, and z seem to be off quite a bit. I set them for a simple project and it was all over the place. I think this might be a simple fix in the settings, but I’m in a little over my head with the machine settings.

THANKS!

[OnefinityCNC (Onefinity Support)]

Check the dip switches, then reload the configuration!

Elite Series Masso Default Machine Settings

Elite Series Masso Machine Settings: (updated: 12/4/24 (600ipm Rapid Change) Before performing the two steps below, ensure the Masso firmware is 5.07 or later (Click Here to learn how to update your firmware, which is different than the below config reset) [Load software on your MASSO Touch - MASSO Top Tip 6] Loading these settings will remove any custom settings (like tools or tool setter, etc) you’ve applied. PART 1 | Physical Ensure your motor dip switches are in the followi…

[lorenmbrenner (Loren)]

Yesss. I double checked all the dip sticks then reloaded from the USB but I still have the same problem.

[lorenmbrenner (Loren)]

I don’t know what I did but it’s working now :). It was a bunch of powering down the machine, checking each motor dipsticks, and rebooting. I got a different USB and tried that with the firmware.