Hey there, I recently updated the firmware for my elite foreman. I may have done something incorrectly. Now my x and y rails move WAY too quickly. My x,y, and z seem to be off quite a bit. I set them for a simple project and it was all over the place. I think this might be a simple fix in the settings, but I’m in a little over my head with the machine settings. THANKS!

Check the dip switches, then reload the configuration! [image] Elite Series Masso Default Machine Settings Masso Default Configuration FAQ Elite Series Masso Machine Settings: (updated: 11/3/25) Part 1, 2, and 3 must be done in order. :one:Part 1: Firmware Before performing the two steps below, ensure the Masso firmware is 5.13 or later (Click Here to learn how to update your firmware, which is different than the below config reset) :down_arrow:Watch the video below to learn how to update the firmware of the Masso Controller down_arrow [Load software on your MASSO Touch - MASSO Top Tip 6] Loading these settings w…

Yesss. I double checked all the dip sticks then reloaded from the USB but I still have the same problem.

I don’t know what I did but it’s working now :). It was a bunch of powering down the machine, checking each motor dipsticks, and rebooting. I got a different USB and tried that with the firmware.

Machine settings seem to be off

Elite Series (Masso & Redline) (Gen 1)

OnefinityCNC (Onefinity CNC Official ✅) February 16, 2025, 1:12am 2

Check the dip switches, then reload the configuration!

Topic		Replies	Views
Elite Series Masso Default Machine Settings Masso Default Configuration FAQ	0	13627	December 16, 2022
My axis readings are wrong Elite Series (Masso & Redline) (Gen 1)	7	185	February 27, 2025
Motors: distance per revolution issue? Elite Series (Masso & Redline) (Gen 1)	16	512	January 16, 2026
From 5.07 to 5.13 then back to 5.10... all out of wack Troubleshooting (Elite Series)	12	395	December 23, 2025
X and homing issues Elite Series (Masso & Redline) (Gen 1)	5	368	April 8, 2024

Machine settings seem to be off

Related topics