Onefinity CNC Firmware 1.2.1 (2/8/23) (X-35/X-50 machines w/ Buildbotics Controller) (Outdated)

[OnefinityCNC (Onefinity CNC Official ✅)]

Ah yes, please see this:

Controller unresponsive after using the pause or stop buttons

There are some rare instances when the controller becomes unresponsive after using the pause or stop buttons. A little background. The controller we use is built off the open source Buildbotics project that existed for a few years before Onefinity’s inception. They use a raspberry pi 3b (released in 2016). It uses a Broadcom BCM2837 chipset. While a file is running, it streams the Gcode from its CPU through the serial bus to the custom board chipset to the motor drivers. The chipset used o…