Problems with Vetric Laser Driver

[OnefinityCNC (Onefinity Support)]

Jtech Laser Controller Settings

For those of you who purchased (or provided their own) the jtech laser add on, as of Firmware update 1.0.9 and later, users no longer have to manually input laser settings. Select “tool” on the flyout menu. From the dropdown menu, select the “laser” option and leave “tool-enable-mode” on disabled It is VERY important that you connect the control (black connector) wire to the control input on the J Tech Photonics, Inc. laser board with the black dot. If you plug it in incorrectly, you will fry …