Projects lose X,Y in the middle of carve!

Sorry if this has been discussed already elsewhere. I am experiencing something odd the last few projects I’ve done. My projects look fine in the software with no errors. But now seemingly for no reason the project will be going well and all of a sudden its like it loses the X,Y and starts carving at a different spot, ruining the project and breaking bits. Im not sure where things are going wrong. Any ideas?

Hey Ben,

in this case I would check for the possible causes in this support document one by one:

You should also check your machine for rectangularity because when it is not properly “square”, the Y carriages can hang and cause this behaviour.