Hey Wayne,
Did the following test. using V Carve Pro 11.5. set sheet size as 32 H x 48 W and .75 thick.
Place one (1) hole at 16 inches in Y and 24 inches in X. Take to machine to see if it would cut it. Than get error message 2.
What could this be?
It seems that on your Onefinity Controller you have an Y maximum soft limit set to 410 mm. THIS IS WRONG. On Journeyman, it should be 816 mm (MOTORS → Motor 1 → Limits → max-soft-limit).
Maybe you should reset the machine’s configuration to the correct default (ADMIN → Configuration). But in case you entered custom values, make note of these and make a configuration backup since you loose them when resetting to defaults.