Upgraded to 1.2.1 - Messed up controller and probing

[OnefinityCNC (Onefinity Support)]

Official Onefinity Joystick Controls (How to changes modes) (Non-Elite Machines Only)

This only applies to X-35/X-50 machines. The Elite series cannot use a joypad. The correct model is ESM-9013 (other model numbers may not move the z axis.) You will never need to install any drivers or software to use the joypad. To use, follow these steps: Insert batterys into the joypad following the diagram below. Insert the usb dongle into any of the 4 usb ports in the back of the Onefinity Control Box. Press the center button on the joypad for a 30-60 seconds, until the leds light up b…