Will not cut to the designed measurements

[AdamsLeatherWorks (Eric Adams)]

Try this one, without all the Wiki information appended at the bottom…

Proper Motor Settings for x-50 rails (Woodworker and Journeyman), with 1616 ball screw configuration

UPDATE: With the release of 1.0.9 firmware, these settings are now part of the default configuartion. Ensure you are on 1.0.9 firmware (https://forum.onefinitycnc.com/t/firmware-update-1-0-9-12-17-21-latest-release/84830) or later and then reset the configuration, choosing your correct machine configuration: How To Reset The Configuration To Defaults (OLD) These settings only apply to X-50 Woodworker and Journeyman with the 1616 ballscrew configuration. Please note: these settings are in M…