Wire management on Rolling Stand Woodworker X50

[MstrODstr]

Other than mounting the controller underneath, I’ve not found any information/recommendations for managing the remaining cables and such when mounting the woodworking X50 on the rolling stand/QCW (secure from below).

I’ve used some wire ties and such; but, I can’t think of where to mount the power strip.

The power cord for the router gets caught between the rails and the frame.

Any suggestions would be greatly appreciated.

[IronCreek (Brian Koehli)]

Mine (WW) fits nicely in a dormer in my 2nd floor small shop. I’ve mounted the controller and surge protector power bar with USB outlets on the wall right next to it. But I’m still pondering what to do with the right side Y cable.

[VanZee (Gene VanZandt)]

https://www.instagram.com/reel/Cg2whefA-Pc/?igshid=YmMyMTA2M2Y=

So I’ve attached a link to my IG reel where I go over my set up. Maybe you can take some ideas from this to help with your set up.

[MstrODstr]

Here’s what i came up with. I think it will still allow me to fold up and move/store if desired although I haven’t actually tried that yet.