X-50 Axis Dimensions?

So I have been putting off my base construction waiting (hoping) for this upgrade but now the question is how wide do I need to make it?

Do I just figure if the X-35 cutting width of 32 1/8"(X) increased by 16" and the original width was 45-3/8" add 16 plus a couple inches for the larger stepper, brings us too… 61-3/8"

Any thoughts?

Posted in the FAQs section

onefinitycncOnefinity SupportLeader


with motor, it’s exactly 61 1/4"…and that’s without giving the motor air to breath or the wire that comes off of it room to freely move or hang…


Well so much for my 48"x60" table LOL