What is the correct y-axis motor distance per revolution setting for the Elite Woodworker?

Bottom of this faq. [image] Elite Series Masso Default Machine Settings Masso Default Configuration FAQ Elite Series Masso Machine Settings: (updated: 11/3/25) Part 1, 2, and 3 must be done in order. :one:Part 1: Firmware Before performing the two steps below, ensure the Masso firmware is 5.13 or later (Click Here to learn how to update your firmware, which is different than the below config reset) :down_arrow:Watch the video below to learn how to update the firmware of the Masso Controller down_arrow [Load software on your MASSO Touch - MASSO Top Tip 6] Loading these settings w…

From the following…https://forum.onefinitycnc.com/t/elite-series-masso-default-machine-settings/17451 Motor: Distance per Revolution: --------------- Inches / MM X-50 Rails: .62992 / 16 X-35 Rails: .39370 / 10

Thank you. Here’s the problem: I’ve got a friend that has a Elite Woodworker and his Masso Y measurement doesn’t match the tape measure. For example, 4" on the Masso is actually 2.5" His distance per revolution setting is .62992 What could be causing this issue?

2.5" x 1.6 = 4" Looks like the pitch is wrong in his axis setup.

The Woodworker has the X35 Y rails.

Reset the default configuration for the FAQ linked for his machines specific size.

Even the ELITE Woodworker has X-35 rails???

Yes, only the Foreman has x50 Y rails.

Ok, but just for your future consideration, there is no mention of this on the EW order page. The X-50 is mentioned, not X-35: "…maintained exceptional rigidity, precision and speed. If you have a business and need to keep output consistent with reduced cutting times the Elite Series is for you. Elite Woodworker X-50 Cutting Area: 32 1/8"“(X) x 32 1/8”(Y) x 5 1/4"(Z)" Thanks for your help. @OnefinityCNC reply was too quick to mark my question as solved. NOW it is solved. Thanks @TMToronto !!

Y Axis Motor - Distance Per Revolution

Elite Series (Masso & Redline) (Gen 1)

OnefinityCNC (Onefinity CNC Official ✅) July 18, 2024, 9:46pm 2

Bottom of this faq.

Topic		Replies	Views
Motors: distance per revolution issue? Elite Series (Masso & Redline) (Gen 1)	16	512	January 16, 2026
Question on Elite X&Y Axis settings Elite Series (Masso & Redline) (Gen 1)	2	151	November 10, 2024
X not equal to Y (solved, adjust trav per rev with an x-50 x rail) Uncategorized	6	1271	September 20, 2021
Why are my default motor driver settings different? Elite Series (Masso & Redline) (Gen 1)	4	72	April 29, 2026
My axis readings are wrong Elite Series (Masso & Redline) (Gen 1)	7	185	February 27, 2025

Y Axis Motor - Distance Per Revolution

Related topics