Z Axis issues with X-50

[349iq2345]

Hey Joseph,

@prfiredog

sometimes its backwards

@OnefinityCNC

If your z moves in the opposite direction than what it’s told to do, disregard the first two steps as it is ALWAYS a wire/connection issue. Check this link for more info: Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)

@349iq2345

there can be many causes for loosing steps. EMI is one of them. I noticed the VFD housing is neither made of metal nor is the VFD enclosed into a steel control cabinet, despite the fact that a VFD is a device intended to be installed in a VFD control cabinet (which serves as faraday cage ). Also all Onefinity cables are not shielded. In industry, all motor and signal cables of a CNC machine are shielded and grounded to prevent EMI.

Have you searched for Z plunge issue in this forum?

@349iq2345

See also:

• Z Axis Moving Unexpectedly (Cutting too shallow or too deep)
• Troubleshooting: Rail is getting hung, stuck, or out of alignment (x35/x50 machines)
• Support: How to Access the inner tube motor wire
• Support: How to determine if a wire or motor is damaged

---