Z axis not responding to remote control

[OnefinityCNC (Onefinity CNC Official ✅)]

Official Onefinity BB Joystick Controls (How to changes modes) For BB (Buildbotics) Controllers

This only applies to Onefinity CNC Machines using the BB Buildbotics controller. [Buildbotics Controller V5 Render] The correct model is ESM-9013 (pro version will not work) (other model numbers may not move the z axis.) You will never need to install any drivers or software to use the joypad. Ensure you are in the right mode with two blue lights on the top. To use, follow these steps: Insert batterys into the joypad following the diagram below. Insert the usb dongle into any of the 4 usb …

Help! My Toolpath says 'Under' or 'Over" (BB controllers) OR 'Soft Alarm on AXIS" (Masso controllers)! (with videos)

While this FAQ was originally wrote for the Non-Elite Machines, the same principal applies to both. Over/under on non-elite controllers and soft alarm on elite controllers mean the same thing, so the below principals apply to all machines. Many new users to the Onefinity CNC often get the machine unboxed, assembled, and moving in a few minutes without ever needing to look at instructions. But then they home the machine and are alarmed when their screen looks like this: (Left picture is non-e…