Good Afternoon everyone! I have the Journeyman and every time I home it when it goes all the way to the left to home the X axis the z slider pushes against the Y axis. Is this normal? The machine shudders a little upon impact but then it just completes the homing like I assume it should. I just wan…

This is normal and by design. Stuttering is normal and part of the stall homing. [Adjusting Stall Homing On The Onefinity CNC]

I can’t find the post but some on the forum printed a spacer so the mount bumped that rather than the z bracket (fears it might be knocking out if tram)

Good morning Andy, I have it bookmarked, here it is: [image] Is it possible to tram X/Y squareness with fixed feet? [stops] Also Stops for Homing

I got it all figured out, Thank you all so much for the great information!

Z Slider mount hitting on Y axis when homing

Original/PRO Series (Buildbotics) (Gen 1)

Razor20 (Jay) January 13, 2022, 11:39pm 3

I had this issue check here Proper Motor Settings for x-50 rails (Woodworker and Journeyman), with 1616 ball screw configuration

Topic		Replies	Views
Z axis will not raise on homing Original/PRO Series (Buildbotics) (Gen 1)	3	607	October 1, 2023
Is this a Stall Homing Issue? (solved, wire issue) Original/PRO Series (Buildbotics) (Gen 1)	1	141	March 12, 2025
Z-Axis keeps going up when homing Troubleshooting (X35/X50)	2	630	February 4, 2024
Elite Homing Hitting Y Rail Elite Series (Masso & Redline) (Gen 1)	2	204	May 18, 2024
Z axis keeps trying to go up against slider Troubleshooting (X35/X50)	4	144	May 27, 2025

Z Slider mount hitting on Y axis when homing

Related topics