I just setup a new woodworker X50. Works great except for the screen. It boots up fine and screen stays on for first minute or so then starts to go blank for a couple seconds then comes back on for 30 seconds or so. This happens constantly no matter if the machine is moving or sitting idle. I have…

[image] How to connect the Touch Display (7, 8, 10.8") Screens When connecting a touchscreen to the Onefinity controller there are a few key items to make it work correctly: Step 1: POWER: Every screen must be connected to external (wall) power to operate correctly. Ski…

I had the same problem last week. It was the first time that it happened or that I noticed that it was happening, and only when I was machining. I don’t spend a lot of time looking at the monitor, but this day I was doing some work beside the monitor and noticed that it would go out for a few second…

Yes, it does seem to just affect the monitor. I am just setting up my machine so I was moving the x and y axis for a few hours with a 2 foot square and dial indicator getting everything squared up. The screen going blank had no effect on the movement of the machine. Except when i was using the scree…

Thanks Onefinity Support Leader. I will go through those instructions again very carefully.

@ChrisM did you resolve this issue? My setup just starting doing the same. Best, _Mike

[image] How to connect the Touch Display (7, 8, 10.8") Screens When connecting a touchscreen to the Onefinity controller there are a few key items to make it work correctly: Step 1: POWER: Every screen must be connected to external (wall) power to operate correctly. Ski…

Mike, Mine was fixed by replacing the HDMI cable. It’s been perfect since.

This happened to me twice today i have new cables. I usually don’t look but was watching today. Only happened since that last update.

Thanks Chris, I will change the cable and see if it fixes my issue…

I had the same issue. It was solved by adding a cheap Ferrite Ring to the cable. I also bought a new cable, but wanted to see if the rings helped first. They did, and I am still using the original cable that came with my machine. Hope that helps.

10.8" screen goes blank for a few seconds

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

OnefinityCNC (Onefinity CNC Official ✅) December 27, 2021, 2:15am 2

Topic		Replies	Views
Wont boot past the blue miage screen on display Troubleshooting (X35/X50)	3	720	March 31, 2025
New machine blinking screen (solved, ensure screen is plugged into wall power) Uncategorized	4	1676	September 22, 2021
10" Touch Screen Blanking Troubleshooting (X35/X50)	27	1767	April 8, 2023
Touch Screen/Monitor TouchScreen	11	1290	July 23, 2021
Factory screen doesn’t work Uncategorized	3	408	October 7, 2022

10.8" screen goes blank for a few seconds

Related topics