My son recently received his X50 woodworker. We set it up just like mine. The touch screen blanks on/off every few seconds. It’s connected direct to the wall plug (15a) dedicated circuit. We have checked and rechecked all wiring then ordered a set of ferrite cores and placed them on both ends of eac…

Display replaced. Working again

Hey Tom, did you try it with another HDMI cable, as I already suggested ? [image] UI freezes frequently I made the experience that there are big differences between HDMI cables, and I mean not only whether they have ferrite cores or not. At the office, I have the monitor image of an Eizo going b…

I did. No change in display behavior

https://www.dropbox.com/s/my0l2won8i71lzg/Video%20Mar%2005%202023%2C%202%2047%2032%20PM.mov?dl=0 Here’s a link to a video

Hey Tom, watched your video. The other day when I suggested here that the EMI which comes from the carbon-brush commutators of the router cannot be shielded because the router is air-cooled and a solution could be to mount the control display at a greater distance from where the router drives by, y…

Yes, but I didn’t video it today. I’m going to take another touch screen (different mfr) tomorrow or Tuesday. I will video prior to switching it out and after

Hey Tom, I believe you without video :slight_smile:. But I don’t know what it could be.

Tom, I was having this issue and figured out that I had my usb cables wrong. One of the USB cables going to the monitor is strictly for power and is plugged into a wall charger while the other is for data and is plugged into the controller USB port. that fixed my blanking issues… Jay

We double checked all of the cables from the start as soon as we experienced the problem. The USB-C w/ power goes to the bottom port and is powered from the power receptacle. The other goes to the controller. We’ve swapped HDMI cables for a braided shielded one, no change. I’m going to try another o…

I have been having this problem as well. My 10.8" display goes blank whenever I turn my Makita router on. Just started doing this. worked for 6 months with no problem. Changed out the brushes in the Makita this morning, but no change.

Problem Solved. Tried another HDMI Cable and the screen no longer blanks out.

10" Touch Screen Blanking

Original/PRO Series (Buildbotics) (Gen 1) Troubleshooting (X35/X50)

349iq2345 March 5, 2023, 11:24pm 2

Hey Tom,

did you try it with another HDMI cable, as I already suggested?

Topic		Replies	Views
10.8" screen goes blank for a few seconds Troubleshooting (X35/X50)	12	1795	April 22, 2022
Touch screen blinking on and off TouchScreen	8	1655	March 25, 2023
Display monitor goes off then in a bit comes back on Original/PRO Series (Buildbotics) (Gen 1)	11	944	July 19, 2023
Touch Screen/Monitor TouchScreen	11	1290	July 23, 2021
Display flickering Uncategorized	7	348	February 14, 2024

10" Touch Screen Blanking

Related topics