When ever I start up my machine the units of measurement default to metric is there any way to make it default to imperial

This seems to be something that is broken in the firmware right now. You can tell it that imperial should be default but the next boot is back on metric.

I didn’t pay attention to it and I homed the machine in metric and when I ran my gcode. Which is in imperial. Things were a little off .

I agree, this needs to be addressed.

[image] msharp: I didn’t pay attention to it and I homed the machine in metric and when I ran my gcode. Which is in imperial. Things were a little off . The display units should not affect the quality/accuracy of the cuts. Can you expand a little on what you mean by “things were a little off…

I was running gcode for a threaded waste board i was making. I had .75 inch pockets at .08 depth with a .125 endmill. As the end mill worked its way out from the center of the pocket the machine was chattering like it was bumping up against something .and when it finished the pocket it stopped with…

Sounds like you may have run into my .75" bug? [image] Weirdest bug ever? Troubleshooting (X35/X50) Okay, all, I have the guys at @OnefinityCNC working this from their end but I wanted to post this up to see if it can be replicated or if it is just a ghost in my machine? …

That’s what my circle looked like . But mine seemed to go away when I rehomed my machine in standard from mm. but probably still related to the same problem

This has been addressed before and OF gave us a new pp to replace the previous one. I chose not to replace it but to run everything, especially circles, in metric. You run the same program in metric and the problem goes away. After getting used to metric I like it better. That chatter only happens i…

[image] alden: ay. After getting used to metr I’m having the same problem with creating my spoilboard making .75" dog holes. It only clunks and makes noises when I try to make the dog holes. I tried changing my Fusion 360 design to metric and putting Onefinity in metric but when I push the pl…

I’m not sure why it is reverting back to english. I’m thinking that maybe 360 metric setting didn’t take. Make sure it didn’t revert back there. When you set Onefinity to metric did the screen read out in metric? I wish you had Vetric. I think it works best with the Onefinty and woodworking in gener…

Default units metric vs imperial

Original/PRO Series (Buildbotics) (Gen 1)

Markevans36301 (Mark L Evans) December 28, 2020, 9:05pm 7

Sounds like you may have run into my .75" bug?

Topic		Replies	Views
Woodworker switching Units Troubleshooting (X35/X50)	6	1884	January 22, 2023
Metric to Imperial Original/PRO Series (Buildbotics) (Gen 1)	5	925	June 9, 2021
Metric Imperial switching Uncategorized	12	960	August 27, 2021
Imperial / Metric Bug? Gen 2 Elite Series	1	98	May 25, 2026
After 1.09 update movement controls now in mm Uncategorized	2	745	February 17, 2022

Default units metric vs imperial

Related topics