Onefinity CNC Firmware 1.2.1 (2/8/23) (X-35/X-50 machines w/ Buildbotics Controller) (Outdated)

[ahandeman (Troy Johnson)]

Many people have stayed during the beta that they needed to put the controller back into the correct mode. Follow the steps here

Official Onefinity Joystick Controls (How to changes modes) (Non-Elite Machines Only)

This only applies to X-35/X-50 machines. The Elite series cannot use a joypad. The correct model is ESM-9013 (other model numbers may not move the z axis.) You will never need to install any drivers or software to use the joypad. To use, follow these steps: Insert batterys into the joypad following the diagram below. Insert the usb dongle into any of the 4 usb ports in the back of the Onefinity Control Box. Press the center button on the joypad for a 30-60 seconds, until the leds light up b…