X50 Turns on, but won't start functioning and no display

1

Got an X50 that the controller turns on, but it doesn’t start as usual. Checked all connections, pushed soft reset button, still nothing. What am I missing?

2

Hey Peter,

does the fan run?

If so next check would be:

If the fan does not run, I would write an E-Mail to support@onefinitycnc.com .

1 Like
3

You nailed it. Display problem. Your point about the fan made me curious. I hooked up my laptop and brought up the display. X50 works fine. (Phew!) Ive got some troubleshooting to do with the Display, but you got me going again. Many thanks

1 Like
4
1 Like