Got an X50 that the controller turns on, but it doesn’t start as usual. Checked all connections, pushed soft reset button, still nothing. What am I missing?

Hey Peter, does the fan run? If so next check would be: How to connect the Touch Display (7, 8, 10.8") If the fan does not run, I would write an E-Mail to support@onefinitycnc.com .

You nailed it. Display problem. Your point about the fan made me curious. I hooked up my laptop and brought up the display. X50 works fine. (Phew!) Ive got some troubleshooting to do with the Display, but you got me going again. Many thanks

[image] No signal on Screen / No video output from controller - Troubleshooting Video Screens If the screen is turning on and showing a blue splash screen but no input video, try the following: (this should be an obvious first step, but make sure everything is plugged in …

X50 Turns on, but won't start functioning and no display

OnefinityCNC (Onefinity CNC Official ✅) November 27, 2023, 5:54pm 4

1 Like

Topic		Replies	Views
X50 not booting up (solved in comments) Troubleshooting (X35/X50)	2	439	October 21, 2023
Controller will not boot up Troubleshooting (X35/X50)	2	1039	April 12, 2022
Fan turns on but nothing Troubleshooting (X35/X50)	10	162	January 11, 2025
10.8" screen goes blank for a few seconds Troubleshooting (X35/X50)	12	1770	April 22, 2022
Large monitor shows no signal	5	579	October 17, 2021

X50 Turns on, but won't start functioning and no display

Related topics